Download the Brochure (3 MB) (right click, save as)

Download Specifications (19 Kb)

Download MSDS (61 Kb)

Download LEED (35 Kb)

Celbar Cellulose Insulation Wall Spray & Loosefill

System Description

Celbar is a blend of specially prepared cellulose fibers, organic in nature, treated with adhesive and fire resistant chemicals. When sprayed in place, the interlocking fibers result in a mass that produces excellent sound and thermal properties.

Celbar is pneumatically spray-applied in wall and floor/ceiling cavities to form a monolithic coating. This process seals cracks and holes in the wallboard, around plumbing and electrical outlets, vent ducts and other irregularities. There are no compressed areas or voids to allow sound leaks, R-value reduction, or air infiltration.

Performance Where it Counts

Celbar provides superior sound transfer control demanded by building designers, owners and occupants. Celbar assemblies perform closer to lab tested STC ratings in the field than do other conventional batt and sound board systems. This is due to the complete coverage and the sealing action of Celbar.

The performance of Celbar compared to other identically constructed wall systems, as documented by laboratory tests is shown below.

The base system and results are as follows

Thermal Performance

Celbar's R-value of 3.8 per inch allows you to design exterior wall systems with higher total R-values. However, R-value alone is not the only measure of a product's thermal effectiveness. To obtain maximum thermal efficiency, air infiltration must be minimized. Sprayed in place, Celbar conforms to any substrate, around pipes, obstructions, and over cracks, reducing air infiltration and forming a highly efficient and effective thermal barrier. It can be sprayed to virtually any exterior stud or furred cavity, and in most cases the wall can be closed up the same day.

Energy Savings Example

In a series of tests, five identical buildings were monitored for KWH usage over an eleven month period. One building utilized sprayed cellulose in the walls, and the other four utilized fiberglass batt insulation. Upon conclusion, the cellulose-insulated building saved 32% of the KWH usage of the other buildings.

Metal Stud Assemblies Construction Detail

STC RATING 55 - 2 1/2" metal studs, 2 layers 5/8" gypsum board on one side, I layer 5/8" gypsum board on the opposite side: 2 l/2" Celbar Spray.

STC RATING 53 - 3 5/8" metal studs, 1 layers 5/8" gypsum board on each side: 2" Celbar Spray.

STC RATING 51 - 2 1/2" metal stud 24" O.C. faced both sides with 5/8" gypsum wallboard: 1 1/2" Celbar Spray.

Wood Assemblies Construction Detail

STC RATING 51 - 2" x 4" wood studs, I layer 5/8" gypsum board on each side: 31/2" Celbar Spray.

STC RATING 50 - 2" x 4" wood studs, 1 layer 5/8" gypsum board on each side: 2" Celbar Spray.

Residential Use

The comfort and maintenance of your home, the cost of your monthly heating/cooling bill, and many more factors are directly related to the performance of insulation. For complete information on maintaining a comfotable home in any climate please visit: http://www.celbar.com/